Allied Telesis AT-S62 - Manual (Page 125)

125
Chapter 7
Port Parameter Commands
This chapter contains the following commands:
ˆ “ACTIVATE SWITCH PORT” on page 126
ˆ “DISABLE INTERFACE LINKTRAP” on page 127
ˆ “DISABLE SWITCH PORT” on page 128
ˆ “DISABLE SWITCH PORT FLOW” on page 129
ˆ “ENABLE INTERFACE LINKTRAP” on page 130
ˆ “ENABLE SWITCH PORT” on page 131
ˆ “ENABLE SWITCH PORT FLOW” on page 132
ˆ “PURGE SWITCH PORT” on page 133
ˆ “RESET SWITCH PORT” on page 134
ˆ “RESET SWITCH PORT COUNTER” on page 135
ˆ “SET SWITCH PORT” on page 136
ˆ “SET SWITCH PORT RATELIMITING” on page 141
ˆ “SHOW INTERFACE” on page 144
ˆ “SHOW SWITCH COUNTER” on page 146
ˆ “SHOW SWITCH PORT” on page 149
ˆ “SHOW SWITCH PORT COUNTER” on page 153
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
For background information, refer to Chapter 6, “Port Parameters” in
the AT-S62 Management Software Menus Interface User’s Guide.