Allied Telesis AT-S62 - Manual (Page 257)

AT-S62 Management Software Command Line Interface User’s Guide
Section II: Advanced Operations 257
SHOW LOG STATUS
Syntax
show log status
Parameter
None.
Description
This command displays information about the event log feature. Figure 26
is an example of the information displayed by this command.
Figure 26. SHOW LOG STATUS Command
The Event Logging field indicates whether the feature is enabled or
disabled. If enabled, the switch stores events in the event log and sends
events to defined outputs. If disabled, no events are stored in the event log
or sent to defined outputs. To enable and disable the event logs, refer to
“ENABLE LOG” on page 241 and “DISABLE LOG” on page 239.
The Number of Output Definitions is the sum of the event log and any
output definitions you might have created. For instance, the number 4 for
Number of Output Definitions in the above example indicates the
existence of three output definitions in addition to the one event log. To
create new output definitions, refer to “CREATE LOG OUTPUT” on
page 234 and “ADD LOG OUTPUT” on page 232.
Example
The following command displays event log status information:
show log status
Event Log Configuration:
Event Logging .................... Enabled
Number of Output Definitions ..... 4