Allied Telesis AT-S62 - Manual (Page 234)

Chapter 14: Event Log and Syslog Server Commands
234 Section II: Advanced Operations
CREATE LOG OUTPUT
Syntax
create log output= output-id destination=syslog
server= ipaddress
[facility=default|local1|local2|local3|local4|local5|local6
|local7] [syslogformat=extended|normal]
Parameters
output Specifies an ID number for the new output definition.
The range is 2 to 20. (The ID 1 is reserved for
temporary (dynamic) storage.)
destination Specifies the destination for the log messages. The
only option currently supported is:
syslog Forwards log messages in syslog format
to a syslog server.
server Specifies the IP address of the syslog server.
facility Specifies a facility level to be added to the events.
default Adds a facility level based on the
functional groupings defined in the RFC
3164 standard. The codes applicable to
the AT-S62 management software and
its modules are shown in Table 6 on
page 236. This is the default setting.
local1 to local7
Adds a set facility code of 17 (LOCAL1)
to 23 (LOCAL7) to all event messages.
For a list of the levels and their
corresponding codes, refer to Table 7
on page 236.
syslogformat Specifies the format of the generated messages. The
possible options are:
extended Messages include the date, time, and
system name. This is the default.
normal Messages do not include the date, time,
and system name.