Allied Telesis AT-S62 - Manual (Page 323)

AT-S62 Management Software Command Line Interface User’s Guide
Section II: Advanced Operations 323
SHOW QOS TRAFFICCLASS
Syntax
show qos trafficclass[= idnumber ]
Parameter
trafficclass Specifies the ID of the traffic class you want to view. You
can specify more than one traffic class at a time. Separate
multiple traffic classes with commas (e.g., 4,5,10).
Description
This command displays the traffic classes on a switch. An example is
shown in Figure 31.
Figure 31. DISPLAY QOS TRAFFICCLASS Command
This command provides the following information about a traffic class:
ˆ Traffic Class ID - The traffic class’ ID number.
ˆ Description - The description of the traffic class.
ˆ Exceed Action - The action taken if the traffic of the traffic class
exceeds the maximum bandwidth.
ˆ Exceed Remark Value - The DSCP replacement value for traffic that
exceeds the maximum bandwidth.
ˆ DSCP value - The replacement value to write into the DSCP (TOS)
field of the packets.
ˆ Max Bandwidth - The maximum bandwidth available to the traffic
class.
ˆ Burst Size - The size of a token bucket for the traffic class.
Traffic Class ID .......... 0
Description ............... Dev Database
Exceed Action ............. Drop
Exceed Remark Value ....... 0
DSCP value ................ 0
Max bandwidth ............. 50
Burst Size ................ 0
Priority .................. 0
Remark Priority ........... No
ToS .......................
Move ToS to Priority ...... No
Move Priority to ToS ...... No
Flow Group List ........... 11
Parent Policy ID .......... 2
Is Active ................. Yes