Allied Telesis AT-S62 - Manual (Page 200)

Chapter 12: File System Commands
200 Section II: Advanced Operations
COPY
Syntax
copy “ sourcefile.ext ” “ destinationfile.ext ”
Parameters
sourcefile.ext Specifies the name of the source file. If the filename
contains spaces, enclose it in double quotes.
Otherwise, the quotes are optional.
destinationfile.ext Specifies the name of the destination file. If the
filename contains spaces, enclose in double
quotes. Otherwise, the quotes are optional.
Description
This command creates a copy of a file in the switch’s file system. Note the
following when using this command:
ˆ Files with the extension UKF are encryption key pairs. These files
cannot be copied, renamed, or deleted from the file system.
ˆ The new filename must be a valid filename from 1 to 16 alphanumeric
characters. The name of the copy must be unique from the other files
in the file system.
ˆ ext is the three-letter file extension, and can be any of the types listed
in Table 3. You must give the copy the same extension as the original
file.
Examples
The following command creates a copy of the configuration file “admin.cfg”
in the switch’s file system and names the copy “admin2.cfg”:
copy admin.cfg admin2.cfg
Table 3. File Extensions and File Types
Extension File Type
.cfg Configuration file
.cer Certificate file
.csr Certificate enrollment request
.key Public encryption key
.log Event log