Allied Telesis AT-S62 - Manual (Page 456)

Chapter 24: Spanning Tree Protocol Commands
456 Section IV: Spanning Tree Protocols
shown in Table 14. You specify the increment of the
desired value. The default is 128 (increment 8).
Description
This command configures the following STP parameter settings for a
switch port:
ˆ Port cost
ˆ Port priority
Examples
The following command sets the port cost to 15 and the port priority to 192
(increment 12) for port 6:
set stp port=6 portcost=15 portpriority=12
The following command sets the port cost to auto-detect on ports 7 to 10:
set stp port=7-10 portcost=auto
Table 14. Port Priority Value Increments
Increment
Port
Priority
Increment
Port
Priority
0 0 8 128
1 16 9 144
2 32 10 160
3 48 11 176
4 64 12 192
5 80 13 208
6 96 14 224
7 112 15 240