Allied Telesis AT-S62 - Manual (Page 383)

AT-S62 Management Software Command Line Interface User’s Guide
Section III: SNMPv3 383
ADD SNMPV3 USER
Syntax
add snmpv3 user= user [authentication=md5|sha]
authpassword =password privpassword =password
[storagetype=volatile|nonvolatile]
Parameters
user Specifies the name of an SNMPv3 user, up to 32
alphanumeric characters.
authentication Specifies the authentication protocol that is used to
authenticate this user with an SNMP entity
(manager or NMS). If you do not specify an
authentication protocol, this parameter is
automatically set to None. The options are:
md5 The MD5 authentication protocol.
SNMPv3 Users are authenticated
with the MD5 authentication protocol
after a message is received.
sha The SHA authentication protocol.
Users are authenticated with the
SHA authentication protocol after a
message is received.
Note: You must specify the
authentication protocol before you
specify the authentication password.
authpassword Specifies a password for the authentication
protocol, up to 32 alphanumeric characters. If you
specify an authentication protocol, then you must
configure an authentication protocol password.
privpassword Specifies a password for the 3DES privacy, or
encryption protocol, up to 32 alphanumeric
characters. This is an optional parameter.
Note: If you specify a privacy password, the privacy
protocol is set to DES. You must also specify an
authentication protocol and password.
storagetype Specifies the storage type of this table entry. This is
an optional parameter. The options are: