Allied Telesis AT-S62 - Manual (Page 219)

AT-S62 Management Software Command Line Interface User’s Guide
Section II: Advanced Operations 219
UPLOAD METHOD=LOCAL
Syntax
upload method=local destfile=” filename”
srcfile|file=appblock
Parameters
method Specifies a local upload.
destfile Specifies a filename for the AT-S62 image file. The file is
assigned this name when stored in the file system. The
name can be from 1 to 32 alphanumeric characters.
Spaces are allowed, but special characters (e.g., /, \, #,
and %) should not be used. The extension should be
“.img”. If the name contains spaces, enclose it in quotes.
srcfile or file Specifies the application block (APPBLOCK), where the
active AT-S62 image file is stored.
Description
This command copies the switch’s active AT-S62 image file from the
application block, where the active AT-S62 image is stored, to the switch’s
file system.
Note
It is unlikely you will ever need to perform this type of upload.
Note
The AT-S62 image file will take up nearly all 2 megabytes of storage
in the file system, leaving little room for other files, such as
configuration files.
The DESTFILE parameter specifies a name for the file. This is the name
given to the AT-S62 image file when it is stored in the file system. The
name should include the extension “.img”.
The equivalent SRCFILE and FILE parameters specify APPBLOCK, for
application block, where the active image file is stored.
Example
The following command uploads the active AT-S62 image from the
switch’s application block to the file system and assigns it the name “sw12
s63 image.img”: