Allied Telesis AT-S62 - Manual (Page 185)

AT-S62 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 185
SET LACP AGGREGATOR
Syntax
set lacp aggregator= name |adminkey= key
[distribution=macsrc|macdest|macboth|ipsrc|ipdest|ipboth]
Parameters
aggregator Specifies the name of the aggregator you want to
modify. The name is case-sensitive.
adminkey Specifies the adminkey number of the aggregator you
want to modify. This is a hexadecimal number between
0x1 and 0xffff.
distribution Specifies one of the following load distribution methods:
macsrc Source MAC address.
macdest Destination MAC address.
macboth Source address/destination MAC
address. This is the default.
ipsrc Source IP address.
ipdest Destination IP address.
ipboth Source address/destination IP
address.
Description
This command modifies the load distribution method of an existing LACP
aggregator. You can identify the aggregator by its name or adminkey. To
display the names and adminkeys of the aggregators on the switch, refer
to “SHOW LACP” on page 189.
Note
You cannot change the name or adminkey of an existing aggregator.
Examples
The following command changes the load distribution method of an LACP
aggregator titled “agg_5” to the source MAC address method:
set lacp aggregator=agg_5 distribution=macsrc