Allied Telesis AT-S62 - Manual (Page 432)

Chapter 23: SNMPv3 Commands
432 Section III: SNMPv3
SET SNMPV3 USER
Syntax
set snmpv3 user= user [authentication=md5|sha]
authpassword =password privpassword =password
[storagetype=volatile|nonvolatile]
Parameters
user Specifies the name of an SNMPv3 user, up to 32
alphanumeric characters.
authentication Specifies the authentication protocol that is used to
authenticate this user with an SNMPv3 entity (or
NMS). The default is no authentication. The options
are:
md5 The MD5 authentication protocol.
Users are authenticated with the
MD5 authentication protocol after a
message is received.
sha The SHA authentication protocol.
Users are authenticated with the
SHA authentication protocol after a
message is received.
authpassword Specifies a password for the authentication
protocol, up to 32 alphanumeric characters.
privpassword Specifies a password for the 3DES privacy, or
encryption protocol, up to 32 alphanumeric
characters. Configuring a privacy protocol
password, turns on the DES privacy protocol.
storagetype Specifies the storage type of this table entry. This is
an optional parameter. The options are:
volatile Does not allow you to save the table
entry to the configuration file on the
switch. This is the default.
nonvolatile Allows you to save the table entry to
the configuration file on the switch.
Description
This command modifies an SNMPv3 User Table entry.