Allied Telesis AT-S62 - Manual (Page 175)

AT-S62 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 175
SHOW SWITCH TRUNK
Syntax
show switch trunk
Parameters
None.
Description
This command displays the names, ports, and load distribution methods of
the static port trunks on the switch. An example of the command is shown
in Figure 17.
Figure 17. SHOW SWITCH TRUNK Command
The command displays the following information:
ˆ Trunk group ID - The ID number of the static port trunk.
ˆ Trunk Status - The operational status of the trunk. Up means at least
one port in the trunk has established a link with a port on the other
device. Down means no ports in the trunk have established a link with
the other device.
ˆ Trunk group name - The name of the static port trunk.
ˆ Trunk method - One of the following load distribution methods:
SRC MAC Source MAC address.
DST MAC Destination MAC address.
SRC/DST MAC Source address/destination MAC address.
SRC IP Source IP address.
DST IP Destination IP address.
SRC/DST IP Source address/destination IP address.
ˆ Ports - The ports of the static port trunk.
Trunk group ID ............ 2
Trunk Status ........... UP
Trunk group name ....... Server11
Trunk method ........... SRC/DST MAC
Ports .................. 12-16