Allied Telesis AT-S62 - Manual (Page 311)

AT-S62 Management Software Command Line Interface User’s Guide
Section II: Advanced Operations 311
traffic class or policy level.
movetostopriority Replaces the value in the 802.1p priority field with the
value in the ToS priority field on IPv4 packets. Options
are:
yes, on, true Replaces the value in the 802.1p priority
field with the value in the ToS priority
field on IPv4 packets.
no, off, false Does not replace the preexisting 802.1p
priority level This is the default.
moveprioritytotos Replaces the value in the ToS priority field with the
802.1p priority field on IPv4 packets. Options are:
yes, on, true Replaces the value in the ToS priority
field with the 802.1p priority field on IPv4
packets.
no, off, false Does not replace the ToS priority field.
This is the default.
sendtomirror Copies the traffic that meets the criteria of the classifiers
to a destination mirror port. Options are:
yes, on, true Copies the traffic that meets the criteria
of the classifiers to a destination mirror
port. You must specify the destination
port by creating a port mirror, as
explained in Chapter 11, “Port Mirroring
Commands” on page 193.
no, off, false Does not copy the traffic to a destination
mirror port. This is the default.
trafficclasslist Specifies the traffic classes to be assigned to the policy.
The specified traffic classes must already exist.
Separate multiple IDs with commas (e.g., 4,11,13).
ingressport Specifies the ingress ports to which the policy is to be
assigned. Ports can be identified individually (e.g.,
5,7,22), as a range (e.g., 18-23), or both (e.g., 1,5,14-
22). The NONE option removes the policy from all
ingress ports to which it has been assigned. The ALL
option adds it to all ports.
A port can be an ingress port of only one policy at a
time. If a port is already an ingress port of a policy, you
must remove the port from its current policy assignment
before adding it to another policy. Alternatively, you can