Allied Telesis AT-S62 - Manual (Page 103)

AT-S62 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 103
SET TIME
Syntax
set time= hh:mm:ss
Parameter
time Specifies the hour, minute, and second for the switch’s
time in 24-hour format.
Description
This command sets the time on the switch. You can use this command to
set the switch’s time if you are not using an SNTP server.
Note
The system’s time when set with this command, are lost whenever
you power cycle or reset the switch. To avoid having to reenter the
date and time, you can configure the SNTP client software so that
the switch automatically obtains this information from an SNTP
server.
Example
The following command sets the switch’s time to 4:34 pm and 52 seconds:
set time=16:34:52