Allied Telesis AT-S62 - Manual (Page 342)

Chapter 19: IGMP Snooping Commands
342 Section II: Advanced Operations
SHOW IP IGMP
Syntax
show ip igmp [hostlist] [routerlist]
Parameters
hostlist Displays a list of the multicast groups learned by
the switch, as well as the ports on the switch that
are connected to host nodes. This parameter
displays information only when there are active
host nodes.
routerlist Displays the ports on the switch where multicast
routers are detected. This parameter displays
information only when there are active multicast
routers.
Description
This command displays the IGMP parameters. Figure 34 illustrates the
information that is displayed by this command without the optional
parameters.
Figure 34. SHOW IP IGMP Command
For an explanation of these parameters, refer to “SET IP IGMP” on
page 338.
An example of the information displayed by the HOSTLIST parameter is
shown in Figure 35.
Figure 35. SHOW IP IGMP Command with HOSTLIST Parameter
IGMP Information:
IGMP Snooping Status ............... Disabled
Multicast Host Topology ............ Single-Host/Port (Edge)
Host/Router Timeout Interval ....... 260 seconds
Maximum Multicast Groups ........... 64
Multicast Router Port(s) ........... Auto Detect
Number of IGMP Multicast Groups: 1
MulticastGroup ......... 01:00:5E:00:01:01
VLAN ID ................ 1
Port/TrunkID ........... 6
HostIP .................
172.16.10.51
Version ................ v2
Time ..................... 21