Allied Telesis AT-S62 User Manual
Page 137

AT-S62 Management Software Command Line Interface User’s Guide
Section I: Basic Operations
137
autonegotiate The port uses Auto-Negotiation
for both speed and duplex mode.
This is the default setting.
10mhalf
10 Mbps and half-duplex mode.
10mfull
10 Mbps and full-duplex mode.
100mhalf
100 Mbps and half-duplex mode.
100mfull
100 Mbps and full-duplex mode.
1000mfull
1000 Mbps and full-duplex mode.
(Applicable only to 1000 Mbps
fiber optic ports on SFP and
GBIC modules.)
Note
A 10/100/1000Base-T twisted pair port operates at 1000 Mbps only
when set to Auto-Negotiation.
mdimode
Sets the wiring configuration of the port. This
parameter applies only to twisted pair ports, and
only when a port’s speed and duplex mode are
set manually. If a port is autonegotiating its
speed and duplex mode, the MDI/MDIX setting
is established automatically and cannot be
changed. The options are:
mdi
Sets the port’s configuration to MDI.
mdix Sets the port’s configuration to MDI-X.
flowcontrol
Specifies the flow control on the port. Flow
control applies only to ports operating in full
duplex mode. When flow control is activated, a
port sends out a PAUSE packet whenever it
wants the end node to stop sending packets.
The options are:
disabled No flow control. This is the default
setting.
enabled
Flow control is activated.
fctrllimit
Specifies the number of cells for flow control. A
cell represents 64 bytes. The range is 1 to
57,344 cells. The default value is 57,344 cells.