Allied Telesis AT-S62 - Manual (Page 80)

Chapter 3: Basic Switch Commands
80 Section I: Basic Operations
SHOW SWITCH
Syntax
show switch
Parameters
None.
Description
This command displays a variety of switch parameters. An example of the
display is shown in Figure 7.
Figure 7. SHOW SWITCH Command
This command displays the following information:
ˆ Application software version and Application software build date - The
version number and build date of the AT-S62 management software.
ˆ Bootloader version and Bootloader build date - The version number
and build date of the AT-S62 bootloader.
ˆ MAC address - The MAC address of the switch. This value cannot be
changed.
Switch Information:
Application Software Version ......... ATS62 v1.4.0
Application Software Build Date ...... Jan 13 2006 16:27:38
Bootloader Version ................... ATS63_LOADER v1.2.0
Bootloader Build Date ................ Nov 14 2005 16:25:19
MAC Address .......................... 00:21:46:A7:B4:43
VLAN Mode ............................ User Configured
Management VLAN ...................... 1 (Default_VLAN)
Ingress Filtering .................... OFF
Active Spanning Tree version ......... RSTP
Mirroring State ...................... Disabled
Enhanced Stacking mode ............... Master
Console Disconnect Timer Interval .... 10 minute(s)
Web Server Status .................... Enabled
Telnet Server status ................. Enabled
MAC address aging time ............... 300 second(s)
Console Startup Mode ................. CLI
Multicast Mode ....................... Forward Across VLANs