Allied Telesis AT-S62 - Manual (Page 63)

AT-S62 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 63
SET IP ROUTE
Syntax
set ip route ipaddress= ipaddress
Parameter
ipaddress Specifies the IP address of the default gateway for the
switch.
Description
This command specifies the IP address of the default gateway for the
switch. This IP address is required if you intend to remotely manage the
device from a remote management station that is separated from the unit
by a router. To display the current gateway address, refer to “SHOW IP
INTERFACE” on page 78.
Example
The following command sets the default gateway to 140.35.22.12:
set ip route ipaddress=140.35.22.12