Allied Telesis AT-S62 - Manual (Page 365)

AT-S62 Management Software Command Line Interface User’s Guide
Section II: Advanced Operations 365
SHOW POE CONFIG
Syntax
show poe config [port= port ]
Parameter
port Specifies a port. You can specify more than one port at
a time. You can specify the ports individually (e.g.,
5,7,22), as a range (e.g., 18-23), or both (e.g., 1,5,14-
22).
Description
Entering this command without specifying a port displays the following
PoE information:
ˆ Maximum available power - The total available power for PoE supplied
by the switch. This value is 400 W for the AT-8524POE switch.
ˆ Power threshold - A percentage of the maximum available power
which, if exceeded by the powered devices, causes the switch to send
an SNMP trap to your management workstation and enter an event in
the event log. At the default setting of 95%, the switch sends an SNMP
trap when the PoE devices require more than 380 W, which is 95% of
400 W, the maximum available power on the AT-8524POE switch.
Entering the command with the PORT parameter, displays this PoE
information about the specified port:
ˆ PoE function - The status of PoE on a port, which can be either
enabled or disabled. The default is enabled.
ˆ Power priority - The port’s priority, which can be critical, high, or low.
The default is low.
ˆ Power limit - The maximum amount of power available to a powered
device. The default value is 15.4 W.
Examples
This command displays general PoE information:
show poe config
This command displays PoE information about port 4:
show poe config port=4