Allied Telesis AT-S62 - Manual (Page 255)

AT-S62 Management Software Command Line Interface User’s Guide
Section II: Advanced Operations 255
SHOW LOG OUTPUT
Syntax
show log output[= output-id ] [full]
Parameters
output Specifies the output definition ID number. If an output
ID number is not specified, all output definitions
currently configured on the switch are displayed.
full Displays the details of the output definition. If not
specified, only a summary is displayed.
Description
This command displays output definition details. An example of the
information displayed by this command is shown in Figure 24.
Figure 24. SHOW LOG OUTPUT Command
The columns in the display are described below:
ˆ Output ID - The ID number of the output definition. The temporary
event log has the ID 1. Syslog server definitions start with ID 2.
ˆ Type - The type of output definition. Temporary identifies the temporary
event log. Syslog indicates a syslog server definition.
ˆ Status - The status of the output definition, which can be enabled or
disabled.
ˆ Details - The event log full action or a syslog server’s IP address. For
the event log, this column contains the log’s full action. Wrap on Full
indicates that the log adds new entries by deleting old entries when it
reaches maximum capacity. Halt on Full means the log stops adding
entries after reaching maximum capacity. To configure the full action
for the event log, refer to “SET LOG FULLACTION” on page 246. For a
syslog definition, this column contains the IP address of the syslog
server.
OutputID Type Status Details
-----------------------------------------------------------
1
Temporary Enabled Wrap on Full
2 Syslog Enabled 169.55.55.55
3 Syslog Enabled 149.88.88.88