Allied Telesis AT-S62 - Manual (Page 172)

Chapter 9: Static Port Trunking Commands
172 Section I: Basic Operations
DELETE SWITCH TRUNK
Syntax
delete switch trunk= name [tgid= value ] port= port
Parameters
trunk Specifies the name of the static port trunk to be
modified.
tgid Specifies the ID number of the trunk. The range is 1 to
6. This parameter is optional.
port Specifies the port to be removed from the existing port
trunk. You can specify more than one port at a time.
Description
This command removes ports from a static port trunk. To completely
remove a port trunk from a switch, see “DESTROY SWITCH TRUNK” on
page 173.
Caution
Disconnect all data cables from the ports of the trunk on the switch
before using this command. Removing a port from a port trunk
without first disconnecting the cables may result in loops in your
network topology, which can produce broadcast storms and poor
network performance.
Note
You cannot remove ports from a trunk that has only two ports
because a static trunk must have a minimum of two ports.
Example
The following command removes port 9 from a port trunk called
Dev_trunk:
delete switch trunk=Dev_trunk port=9