Allied Telesis AT-S62 - Manual (Page 354)

Chapter 20: Denial of Service Defense Commands
354 Section II: Advanced Operations
SET DOS TEARDROP
Syntax
set dos teardrop port= port state=enable|disable
[mirroring=yes|no|on|off|true|false|enabled|disabled]
Parameters
port Specifies the switch ports on which you want to enable
or disable this DoS defense. You can select more than
one port at a time.
state Specifies the state of the DoS defense. The options
are:
enable Activates the defense.
disable Deactivates the defense. This is the default.
mirroring Specifies whether the examined traffic is copied to a
mirror port. Options are:
yes, on, true Traffic is mirrored. These values are
enabled equivalent.
no, off, false Traffic is not mirrored. This is the
disabled default. These values are equivalent.
Description
This command activates and deactivates the Teardrop DoS defense.
In this DoS attack, an attacker sends a packet in several fragments with a
bogus offset value, used to reconstruct the packet, in one of the fragments
to a victim. This results in the victim being unable to reassemble the
packet, possibly causing it to freeze operations.
The defense mechanism for this type of attack has all ingress IP traffic
received on a port sent to the switch’s CPU. The CPU samples related,
consecutive fragments, checking for fragments with invalid offset values. If
one is found, the following occurs:
ˆ The switch sends a trap to the management stations.
ˆ The switch blocks all traffic on the port for one minute.
Because the CPU examines only a sampling of the ingress IP traffic on a
port, there is no guarantee that the switch will catch or prevent all
occurrences of this attack.