Allied Telesis AT-S62 - Manual (Page 447)

447
Chapter 24
Spanning Tree Protocol Commands
This chapter contains the following commands:
ˆ “ACTIVATE STP” on page 448
ˆ “DISABLE STP” on page 449
ˆ “ENABLE STP” on page 450
ˆ “PURGE STP” on page 451
ˆ “SET STP” on page 452
ˆ “SET STP PORT” on page 455
ˆ “SET SWITCH MULTICASTMODE” on page 457
ˆ “SHOW STP” on page 459
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
For background information, refer to Chapter 22, “Spanning Tree
and Rapid Spanning Tree Protocols” in the AT-S62 Management
Software Menus Interface User’s Guide.