Allied Telesis AT-S62 - Manual (Page 131)

AT-S62 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 131
ENABLE SWITCH PORT
Syntax
enable switch port= port
Parameter
port Specifies the port to enable. You can specify more than
one port at a time. You can specify the ports individually
(for example, 5,7,22), as a range (for example, 18-23),
or both (for example, 1,5,14-22).
Description
This command enables a port. When a port is enabled, it forwards traffic.
The default setting for a port is enabled.
Example
The following command enables ports 1 to 4:
enable switch port=1-4
Equivalent Command
set switch port= port status=enable
For information, see “SET SWITCH PORT” on page 136.