Allied Telesis AT-S62 - Manual (Page 187)

AT-S62 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 187
SET LACP SYSPRIORITY
Syntax
set lacp syspriority=0x priority
Parameters
syspriority Specifies the LACP system priority value for a switch.
This is a hexadecimal value from 0x1 to 0xffff. The
lower the number, the higher the priority. The default is
0x0080.
Description
This command sets the LACP priority of the switch. This parameter is used
whenever the two devices connected by an aggregate trunk encounter a
conflict creating the trunk. The lower the number, the higher the priority.
The settings on the device with the higher priority takes precedence over
the settings on the other device. If both devices have the same system
LACP priority value, the settings on the switch with the lowest MAC
address take precedence.
Example
The following command sets the LACP priority on the switch to 0x8000:
set lacp syspriority=0x8000