Allied Telesis AT-S62 - Manual (Page 57)

AT-S62 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 57
RESTART REBOOT
Syntax
restart reboot
Parameters
None.
Description
This command resets the switch. The switch runs its internal diagnostics,
loads the AT-S62 management software, and configures its parameter
settings using the active boot configuration file. The reset can take from 20
seconds to two minutes to complete, depending on the number and
complexity of the commands in the active boot configuration file. The
switch does not forward traffic during the reset process. Some network
traffic may be lost.
Note
Be sure to use the SAVE CONFIGURATION command to save your
changes before resetting the switch. Any unsaved changes are lost.
Your local or remote management session with the switch ends when the
unit is reset. You must reestablish the session to continue managing the
unit.
Example
The following resets the switch:
restart reboot