Allied Telesis AT-S62 - Manual (Page 163)

AT-S62 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 163
SHOW SWITCH FDB
Syntax
show switch fdb [address= macaddress ] [port= port ]
[status=static|dynamic|multicast] [vlan= name ]
Parameters
address Specifies a MAC address. Use this parameter to determine
the port on the switch on which a particular MAC address
was learned (dynamic) or assigned (static). The address can
be entered in either of the following formats:
xxxxxxxxxxxx or xx:xx:xx:xx:xx:xx
port Specifies a port on the switch. Use this parameter to view all
addresses learned on a particular port. You can specify more
than one port.
status Specifies the type of MAC addresses you want to view.
Choices are static, dynamic, and multicast. If no status is
stated, the command displays the static and dynamic unicast
addresses.
vlan Specifies a VLAN name. Use this parameter to view the MAC
addresses learned or assigned to the ports of a particular
VLAN on the switch.
Note
You can specify more than one parameter at a time with this
command.
Description
This command displays the unicast and multicast MAC addresses learned
or assigned to the ports on the switch and stored in the switch’s MAC
address table.