Allied Telesis AT-S62 User Manual
Page 298
Chapter 17: Quality of Service (QoS) Commands
298
Section II: Advanced Operations
parameter. This is the default.
tos
Specifies a replacement value to write into the Type
of Service (ToS) field of IPv4 packets. The range is
0 to 7.
A new ToS value can be set at all three levels: flow
group, traffic class, and policy. A ToS value
specified in a flow group overrides a ToS value
specified at the traffic class or policy level.
movetostopriority
Replaces the value in the 802.1p priority field with
the value in the ToS priority field on IPv4 packets.
Options are:
yes, on, true Replaces the value in the 802.1p
priority field with the value in the ToS
priority field on IPv4 packets.
no, off, false Does not replace the preexisting
802.1p priority level This is the
default.
moveprioritytotos
Replaces the value in the ToS priority field with the
802.1p priority field on IPv4 packets. Options are:
yes, on, true
Replaces the value in the ToS
priority field with the 802.1p priority
field on IPv4 packets.
no, off, false
Does not replace the ToS priority
field. This is the default.
flowgrouplist
Specifies the flow groups to be assigned to the
traffic class. The specified flow groups must already
exist. Separate multiple IDs with commas (e.g.,
4,11,13).
Description
This command creates a new traffic class.
Note
For examples of command sequences used to create entire QoS
policies, refer to “CREATE QOS POLICY” on page 288.