Allied Telesis AT-S62 - Manual (Page 250)

Chapter 14: Event Log and Syslog Server Commands
250 Section II: Advanced Operations
SHOW LOG
Syntax
show log[=temporary] [full] [module= module ] [reverse]
[severity= severity ]
Parameters
log Specifies the event log you want to view. There is
only one option:
temporary Displays the events stored in the
temporary event log.
full Specifies the amount of information to be displayed.
Without this option, the log displays the time, module,
severity, and description for each entry. With it, the
log also displays the filename, line number, and
event ID.
module Specifies the AT-S62 module whose events you want
displayed. For a list of modules, refer to Table 8 on
page 251.
reverse Specifies the order of the events in the log. Without
this option, the events are displayed oldest to newest.
With this option, the events are displayed newest to
oldest.
severity Specifies the severity of events to be displayed. The
options are:
all Displays events of all severity levels.
severity Displays events of a particular severity.
Choices are I for Informational, E for Error,
W for Warning, and D for Debug. You can
select more than one severity at a time (for
example, E,W). For a definition of the
severity levels, see Table 9, “Event Log
Severity Levels” on page 253. The
defaults are I, E, and W.
Description
This command displays the entries stored in the event log.