Allied Telesis AT-S62 - Manual (Page 364)

Chapter 21: Power Over Ethernet Commands
364 Section II: Advanced Operations
SET POE THRESHOLD
Syntax
set poe threshold= value
Parameters
threshold Specifies the threshold as a percentage of the total
amount of PoE available. The range is 1 to 100.
Description
The PoE threshold sends an SNMP trap to your management workstation
and enters an event in the event log when the total power requirements of
the powered devices exceeds the specified percentage of the total
maximum power available on the switch. At the default setting of 95%, the
switch sends an SNMP trap when the PoE devices require more than 380
W, which is 95% of 400 W, the maximum available power on the
AT-8524POE switch. The threshold is adjustable. Of course, for your
management workstations to receive traps from the switch, you must
configure SNMP on the switch by specifying the IP addresses of the
workstations.
Examples
The following command sets the threshold to 80% of the available power:
set poe threshold=80