Allied Telesis AT-S62 - Manual (Page 469)

AT-S62 Management Software Command Line Interface User’s Guide
Section IV: Spanning Tree Protocols 469
SET RSTP PORT
Syntax
set rstp port= port [pathcost|portcost= cost |auto]
[portpriority= portpriority ]
[edgeport=yes|no|on|off|true|false]
[ptp|pointtopoint=yes|no|on|off|true|false|autoupdate]
[migrationcheck=yes|no|on|off|true|false]
Parameters
port Specifies the port you want to configure. You can
specify more than one port at a time. You can specify
the ports individually (for example, 5, 7, 22), as a range
(for example, 18-23), or both (for example, 1, 5, 14-22).
pathcost or Specifies the port’s cost. The parameters are
portcost equivalent. The spanning tree algorithm uses the cost
parameter to decide which port provides the lowest cost
path to the root bridge for that LAN. The options are:
cost A number for the port cost. The range is 1
to 200,000,000.
auto Automatically sets the port cost according
to the speed of the port. This is the default.
Table 16 lists the port cost with auto-
detect.
Table 17 lists the RSTP port costs with
Auto-Detect when the port is part of a port
trunk.
Table 16. RSTP Auto-Detect Port Costs
Port Speed Port Cost
10 Mbps 2,000,000
100 Mbps 200,000
1000 Mbps 20,000
Table 17. RSTP Auto-Detect Port Trunk Costs
Port Speed Port Cost
10 Mbps 20,000