Allied Telesis AT-S62 - Manual (Page 116)

Chapter 6: SNMPv2 and SNMPv2c Commands
116 Section I: Basic Operations
DISABLE SNMP COMMUNITY
Syntax
disable snmp community= community
Parameter
community Specifies an SNMP community string to disable on
the switch. This parameter is case sensitive.
Description
This command disables a community string on the switch, while leaving
SNMP and all other community strings active. IP addresses of
management stations or trap receivers assigned to the community string
are also disabled. A disabled community string cannot be used by a
management station to access the switch.
Example
The following command deactivates the SNMP community string
“sw1200” and the IP addresses of any management stations and trap
receivers assigned to the community string:
disable snmp community=sw1200