Allied Telesis AT-S62 - Manual (Page 308)

Chapter 17: Quality of Service (QoS) Commands
308 Section II: Advanced Operations
omitted or set to NONE. Options are:
yes, on, true Replaces the user priority value in the
packets with the new value specified
with the PRIORITY parameter.
no, off, false Does not replace the user priority value
in the packets with the new value
specified in with the PRIORITY
parameter. This is the default.
tos Specifies a replacement value to write into the Type of
Service (ToS) field of IPv4 packets. The range is 0 to 7.
A new ToS value can be set at all three levels: flow
group, traffic class, and policy. A ToS value specified in
a flow group overrides a ToS value specified at the
traffic class or policy level.
movetostopriority Replaces the value in the 802.1p priority field with the
value in the ToS priority field on IPv4 packets. Options
are:
yes, on, true Replaces the value in the 802.1p priority
field with the value in the ToS priority
field on IPv4 packets.
no, off, false Does not replace the preexisting 802.1p
priority level This is the default.
moveprioritytotos Replaces the value in the ToS priority field with the
802.1p priority field on IPv4 packets. Options are:
yes, on, true Replaces the value in the ToS priority
field with the 802.1p priority field on IPv4
packets.
no, off, false Does not replace the ToS priority field.
This is the default.
classifierlist Specifies the classifiers to be assigned to the flow
group. The specified classifiers replace any classifiers
already assigned to the flow group. Separate multiple
classifiers with commas (e.g., 4,7,8). The classifiers
must already exist. The NONE options removes all
classifiers currently assigned to the flow group without
assigning any new ones. To add classifiers without
replacing those already assigned, see “ADD QOS
FLOWGROUP” on page 282.