Allied Telesis AT-S62 User Manual
Page 59
AT-S62 Management Software Command Line Interface User’s Guide
Section I: Basic Operations
59
Note
For a list of default values, refer to Appendix A, “AT-S62 Default
Settings” in the AT-S62 Management Software Menus Interface
User’s Guide.
This command does not change the assignment of the active boot
configuration file, the configuration file the switch uses the next time it is
reset. If you reset or power cycle the switch, the switch uses the previous
configuration. To change the active boot configuration file, refer to “SET
CONFIG” on page 205.
Your local or remote management session with the switch ends when you
reset the switch. You must reestablish the session to continue managing
the switch.
Examples
The following command configures the switch using the configuration file
named
switch12.cfg
:
restart switch config=switch12.cfg
The following command resets the switch to its default values:
restart switch config=none
The following command resets the switch:
restart switch
Equivalent Command
restart reboot
For information, see “RESTART REBOOT” on page 57.