Allied Telesis AT-S62 - Manual (Page 239)

AT-S62 Management Software Command Line Interface User’s Guide
Section II: Advanced Operations 239
DISABLE LOG
Syntax
disable log
Parameters
None.
Description
This command disables the event log module. When the log module is
disabled, the AT-S62 management software stops storing events in the
event logs and sending events to output definitions. The default setting for
the event logs is enabled.
Note
The event log module, even when disabled, still logs all AT-S62
initialization events that occur when the switch is reset or power
cycled. Any switch events that occur after AT-S62 initialization are
recorded only if the event log module is enabled.
Examples
The following command disables the event log on the switch:
disable log