Allied Telesis AT-S62 - Manual (Page 158)

Chapter 8: MAC Address Table Commands
158 Section I: Basic Operations
DELETE SWITCH FDB|FILTER
Syntax
delete switch fdb|filter
macaddress|destaddress=
macaddress vlan= name | vid
[status=static|multicast]
Note
The FDB and FILTER keywords are equivalent.
Parameters
macaddress or Deletes a dynamic or static unicast or multicast MAC
destaddress
address from the MAC address table. The address can
be entered in either of the following formats:
xxxxxxxxxxxx or xx:xx:xx:xx:xx:xx
This parameter must be accompanied with the VLAN
parameter.
vlan Specifies the VLAN where the address was learned or
assigned. The VLAN can be specified by name or VID.
This parameter must be used when the MACADDRESS
or DESTADDRESS parameter specifies a specific MAC
address.
status Deletes a specific type of MAC address. Options are:
static Deletes all static unicast MAC
addresses.
multicast Deletes all static multicast
addresses.
Description
This command deletes dynamic and static unicast and multicast
addresses from the switch’s MAC address table.
Note
You cannot delete the switch’s MAC address, an STP BPDU MAC
address, or a broadcast address.