Allied Telesis AT-S62 User Manual
Page 82
Chapter 3: Basic Switch Commands
82
Section I: Basic Operations
To enable or disable the server, refer to “ENABLE HTTP SERVER” on
page 581 and “DISABLE HTTP SERVER” on page 580.
Telnet server status - The status of the Telnet server. When the Telnet
server is disabled, you cannot remotely manage the switch using the
Telnet application protocol. The default setting is enabled. To enable or
disable the server, refer to “ENABLE TELNET” on page 51 and
“DISABLE TELNET” on page 45.
MAC address aging time - The current value for the MAC address
aging timer. The switch uses the aging timer to delete inactive dynamic
MAC addresses from the MAC address table. To set this value, refer to
“SET SWITCH AGINGTIMER|AGEINGTIMER” on page 161.
Console startup mode - The management interface —menus or
command line — that initially appears when you start a local or remote
management session. The default is the command line interface. To
set the startup mode, refer to “SET SWITCH CONSOLEMODE” on
page 39.
Multicast Mode - The multicast mode, which determines the behavior
of the switch when forwarding ingress spanning tree BPDU packets
and 802.1x port-based access control EAPOL packets To set the
multicast mode, refer to “SET SWITCH MULTICASTMODE” on
page 457.
Example
The following command displays the switch information described above:
show switch