beautypg.com

Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT User Manual

Page 96

background image

AlliedView™-EMS 3.11 Device Management Guide

Page 96 of 402

Interface Info -> Standard

Error Statistics -> Standard

Spanning Tree Info

Utilization

Displays the port's utilization information.


Interface Info

Displays port statistics such as the number of frames received and transmitted on

the port, bytes received and transmitted on the port, and port status.

Note

- Valid MIB Set values for the Administration Status parameter are 'up' and

'down'. Attempting to set this parameter to any other value will result in the error

message: "The error occurred with 'Set' operation. Error: bad value.".


Error Statistics

Displays error statistics such as alignment error frames and carrier sense errors.


Detail Info

Displays detailed port information such as duplex mode.

Note

- The current firmware version does not allow the Port Name parameter to be

set to NULL. Attempting to set this parameter to NULL will result in the error
message: "The error occurred with 'Set' operation. Error: bad value.".


Spanning Tree Info

Displays the port's spanning tree parameters.

Note

- The current firmware version does not allow the Port parameter to be

configured. Attempting to configure this parameter will result in the error message:
"The error occurred with 'Set' operation. Error: readOnly".


Port Security

Displays the port security attributes for each physical port present in the switch.


Enable

Enables the port.


Disable

Disables the port.


Port Mirroring

Displays port mirroring parameters and allows configuration of port mirroring state
and port's source list.

Note

- Valid MIB Set values for the Port Mirroring Configuration Entry Status

parameter are 'active', 'not in service' and 'destroy'. Attempting to set this