beautypg.com

Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT User Manual

Page 24

background image

AlliedView™-EMS 3.11 Device Management Guide

Page 24 of 402

mode. As a result, the speed label that will be displayed on the port image and its
corresponding DUP LED will depend on the actual speed and duplex mode detected

by the device.

Note

- Valid MIB Set values for the Port Flow Control and Port Back Pressure

parameters are 'disable' and 'enable'. Attempting to set these parameters to

'unknown' will cause them to be set to 'enable'.

Note

- The Port CoS/QoS Priority and Port STP State parameters are not applicable

to the AT-9400 series and should be ignored.

Note

- AT-94xxTs/XP: The current firmware version returns the value 'unknown' for

the Port Speed parameter of the XFP ports.

Note

- AT-94xxTs/XP: The Port Speed and Mode parameter of the XFP ports has a

fixed value of 'auto sense' and cannot be configured.

Note

- The Port MDIO parameter is not applicable to the AT-9408LC/SP.


Spanning Tree Info

Displays the port's spanning tree parameters.

Note

- Setting a port's Port parameter to 'disabled' does not automatically set the

Port State parameter under Detail Info to 'disabled'. As a result, the port's image

may not turn red as expected.

Note

- The current firmware version accepts values in the range [0-255] inclusive for

the Port Priority parameter regardless of the active spanning tree protocol version.

Note

- The current firmware version accepts values in the range [0-65535] inclusive

for the Port Path Cost parameter regardless of the active spanning tree protocol

version.


Enable

Enables the port.

Note

- Under the Sun Solaris platform, the Device Manager application may

terminate abnormally if multiple ports have been selected and each dialog box with

the message "May I set 'atiswitchPortState.n' to up" is clicked one after the other.


Disable

Disables the port.

Note

- Under the Sun Solaris platform, the Device Manager application may

terminate abnormally if multiple ports have been selected and each dialog box with
the message "May I set 'atiswitchPortState.n' to down" is clicked one after the other.


Port Mirroring