Port menu – Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT User Manual
Page 119

AlliedView™-EMS 3.11 Device Management Guide
Page 119 of 402
History Control Table
Displays RMON History table.
Alarm Table
Displays RMON Alarm table.
Event Table
Displays RMON Event table.
Event Log
Displays RMON Event log.
Segment Info
Displays number of segments and others.
Segment Status
Displays RMON configuration information of each segment.
Port Menu
From the Port menu, you can view and edit MIB information about hub's ports.
Statistics
Displays port statistics such as number of frames received/transmitted on the port,
bytes received/transmitted on the port and port status.
Status
Displays whether the port is enabled or disabled, whether it is partitioned and other
status information.
Detail Status
Displays information such as port name, LED status and polarity.
Note
- A link between a port on the hub and a port on another device can only be
established if the port on the other device is configured to auto-negotiate.
Security Info
Displays source MAC addresses of frames received on the port.
Note
- Valid MIB Set values for the Learn Action parameter are 'inactive' and 'active'.
Attempting to set this parameter to any other value will result in the error message
"The error occurred with 'Set' operation. Error: bad value.".
Note
- The current firmware version does not allow the user to configure the MAC
Address parameter. Attempting to configure it will result in the error message "The
error occurred with 'Set' operation. Error: bad value.".