Routing menu – Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT User Manual
Page 267

AlliedView™-EMS 3.11 Device Management Guide
Page 267 of 402
•
00100000 - ping
•
01000000 - web
•
10000000 - telnet
•
11100000 - all
but may not be configured.
Date and Time
Displays and configures the current date and time of the device.
MAC Address Table
Displays a list of static MAC addresses configured on the switch.
Note
- The MIB (atiStackSwitch.mib ? L2+ Models: v2.36 / L3 Models: v2.38) supported by
the current firmware version defines the Module ID, Port ID and Port List parameters as
"read-write". As a result, Device Manager displays these parameters as configurable objects.
However, attempting to configure these parameters will show that the firmware does not
accept any value.
Note
- The only valid MIB Set value for the Status parameter is "destroy". Attempting to set
this parameter to any other value may result in the value being ignored or the error
message: "The error occurred with 'Set' operation. Error: bad value."
Note
- L3 Models: This table cannot be viewed using SNMPv3.
Reset
Resets the switch.
Telnet
Starts a Telnet connection to the switch.
WEB Browser
Connects to the switch's HTTP server.
Routing Menu
From the Routing menu, you can view and edit information about the switch's routing
functions.
IP
ARP Table
Displays the ARP cache on the switch.
Address Table
Displays the list of IP interfaces on the switch.
Route Table