Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT User Manual
Page 272

AlliedView™-EMS 3.11 Device Management Guide
Page 272 of 402
Displays Port Mirroring parameters and allows you to create/delete a port mirror.
Note
- The current firmware version does not allow the Port Mirroring Status
parameter to be set to 'enabled' if, upon device startup, the Port Mirroring feature is
disabled.
Note
- L2+ Models: The current firmware version does not allow the Mirroring
Source Port (Ingress) and Mirroring Source Port (Egress) parameters to be set to
NULL.
Note
- L3 Models: The current firmware version does not allow the Mirroring
Source Port (Ingress) and Mirroring Source Port (Egress) parameters to be
configured.
Note
- The current firmware version does not allow the Mirroring Destination Port
parameter to be set to 0.
Note
- The Mirroring Source Module, Mirroring Source Port and Mirroring
Destination Module parameters are not applicable to the AT-9400 series and should
be ignored.
MAC Address Security
Displays MAC Address Security parameters and allows you to set the security level
for dynamic and static MAC addresses learned and assigned to a port.
DoS Defense
Displays DoS Defense parameters and allows you to enable/disable a defense
mechanism on a port.
Note
- The current firmware version returns 'noSuchName' for the Module ID and
Port Number parameters under each Attack Type option.
Note
- The Attack Mirror Port parameter under each Attack Type option is already
obsolete and should be ignored.
Note
- The Attack Mirror Port Status parameter is not applicable to the SYN Flood
and Smurf defenses and should be ignored.
LAN IP Subnet
Displays LAN IP address and subnet mask
SYN Flood Config
Displays syn flood attack type configuration
Smurf Config
Displays smurf attack type configuration.