Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 167)

AlliedView™-EMS 3.11 Device Management Guide Page 167 of 402
Note - The DLCMI Status and Row Status parameters are not applicable to the AT-
AR700S series and should be ignored.
Note - The following parameters are implemented as 'read-only':
• DLCMI State
• Address Type
• Address Length
• Polling Interval of Successive Status
• Polling Interval of Full Status Enquiry
• Error Threshold
• Monitored Error Events
• Max Supported VC Numbers
• Multicast Type
Virtual Circuits
Displays Frame Relay circuit statistics.
Note - The following parameters are not applicable to the AT-AR700S series and
should be ignored:
• Multicast Type
• Type
• Discards
• Received DEs
• Sent DEs
• Logical Interface Index
• Row Status
Note - The following parameters are implemented as 'read-only':
• State
• CIR
• Maximum Line Speed
• Throughput
Errors
Displays information about errors related to the Frame Relay module.
Note - The Faults and Fault Time parameters are not applicable to the AT-AR700S
series and should be ignored.
DS1
DS1 Config
Displays DS1 configuration.
Note - The current firmware version returns a 'noSuchName' value for the Port
Number parameter.