Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 363)

AlliedView™-EMS 3.11 Device Management Guide Page 363 of 402
Note - The current firmware version returns 'not available' for the following
parameters:
o
Port Link State
o
Port Type
o
Port Speed
o
Port Duplex Mode
o
Port Autonegotiation State
Voice
Displays information for each voice port. Information displayed will vary depending
on the protocol used : H.323, Media Gateway Control (MGCP), or Session Initiation
(SIP).
Note - H.323 : The Port Capability parameter does not display all capabilities used
during call setup.
Note - MGCP : The current firmware version returns 'deleted' for the Port State
parameter even if an MGCP port has already been created.
Note - MGCP : The current firmware version returns 'data -> '
instead of actual values for the following parameters:
o
Port Operational State
o
Port Type
o
Port Profile
o
Port Domain
o
Port End Point Identifier
o
Port Package
o
Port Call Agent
o
Port Notified Entity
o
Port Digit Map
o
Port Network Loss Rate
Note - MGCP : The current firmware version returns '0' instead of actual values for
the following parameters:
o
Port Suspicion Threshold
o
Port Disconnection Threshold
o
Port Initial Retransmission Delay
o
Port Maximum Retransmission Delay
o
Port History Time
o
Port Maximum Propagation Delay
Note - SIP : The current firmware version returns 'Not Available' for the Port
Registration Time parameter.