Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 178)

AlliedView™-EMS 3.11 Device Management Guide Page 178 of 402
Network Info
Displays network-related information such as the addresses of the default gateway
and the agents.
Note - The current firmware version returns an initial value of '???(0)' for the Action
parameter.
Note - Valid MIB Set values for the Action parameter are 'reset' and 'defaultConfig'.
The 'saveConfig' value is nonfunctional in the current firmware release and selecting
it may cause the SNMP client on the device to stop responding to SNMP commands.
To save changes made via SNMP to the switch's configuration file, use one of the
other management interfaces (i.e. menu, command line, web browser).
Device Info
Displays general information about the switch.
Note - AT-8550SP: The current firmware version returns a value of 'other' for the
Uplink A Port Type and Uplink B Port Type parameters if copper SFPs are inserted
in the SFP module expansion slots.
Uplink Info
Displays uplink information of the switch.
Note - The current firmware version returns 'not present' for the Type parameter.
MAC Address Table
Displays a list of static MAC addresses configured on the switch.
Note - The MIB (atiStackSwitch.mib v2.28) supported by the current firmware
version defines the Module ID, Port ID, and Port List parameters as "read-write". As
a result, Device Manager displays these parameters as configurable objects.
However, attempting to configure these parameters will show that the firmware
does not accept any value.
Note - The only valid MIB Set value for the Status parameter is 'destroy'. Attempting
to set this parameter to any other value may result in the value being ignored or the
error message: "The error occurred with 'Set' operation. Error: bad value."
Reset
Resets the switch.
Telnet
Starts a Telnet connection to the switch.
WEB Browser
Connects to the switch's HTTP server.