Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 382)

AlliedView™-EMS 3.11 Device Management Guide Page 382 of 402
Note - Configuring the Beacon Period parameter will result in the error message:
"The error occurred with 'Set' operation. Error: time out occurred." However, the
new value is still set successfully.
Note - Values for the Desired SSID parameter are displayed as octet strings.
However, this parameter accepts input values in text string format.
Note - The following parameters are "read-only" and are not configurable:
o
Power Management Mode
o
Association Response Timeout
o
Multi Domain Capability Implemented
o
Multi Domain Capability Enabled
Authentication Algorithms
Displays all the authentication algorithms supported by the stations.
Note - Only one authentication algorithm can be enabled at any one time. Setting the
Enabled parameter of one algorithm to 'true' will automatically cause the Enabled
parameter of the other algorithm to be set to 'false'.
Privacy
Displays privacy information.
Note - The WEP Key Mapping Length and Exclude Unencrypted parameters are not
supported by the current firmware version and should be ignored.
Multi Domain Capability
Displays multi domain capability information.
Note - The current firmware version does not allow the parameters under this table
to be configured.
MAC Attributes
Operation
Displays MAC attributes pertaining to the operation of the MAC.
Counters
Displays attributes that are MAC counters.
Resource Type Attributes
Resource Type ID Name
Displays resource type id name.
Resource Info
Displays information that identifies the source of the implementation.