Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 326)

AlliedView™-EMS 3.11 Device Management Guide Page 326 of 402
Note - Setting the Module Reset parameter of media converter line cards to 'yes' will
not reset the line cards.
Note - The Module Reset parameter always displays the value '???(0)'.
Note - The Module Operation Mode parameter of CPMs always displays '???(0)'.
Port Info
Displays the port cofigurable parameters. Options to view all/per module
information are displayed.
Port Statistics
Displays the basic port statistics configuration information. Options to view all/per
module information are displayed.
Remote Line Card Info
Displays the Remote Line Card information of the AT-CMxx series line cards.
Remote Module Info
Displays the module info of the line cards.
Note - The current firmware version does not allow the Remote Local
Module Name parameter to be configured.
Remote Port Info
Displays the remote port information of the line cards.
Note - The current firmware version does not allow the Remote Port Speed
parameter to be configured.
Note - The current firmware version does not allow the Remote Ingress Rate
Limit and Remote Egress Rate Limit parameters to be configured.
Remote SFP Info
Displays the remote SFP of the AT-CM2K0s and AT-CM70S line cards.
Remote Port Statistics Info
Displays the remote port statistics information of the line cards.
OAM Menu
From the OAM Menu, you can view information about OAM capabilities of the device.
OAM Config
Displays information about the device's administration status, max OAM PDU size
and configuration revision.