Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 129)

AlliedView™-EMS 3.11 Device Management Guide Page 129 of 402
Virtual Channel (VC) Cross Connect
Displays configuration and state information of a bi-directional VC cross connect.
Note - The Virtual Channel (VC) Cross Connect sub-menu option does not display
the correct parameters. Instead, it displays the sub-menu option name as a
parameter with a value of 'noSuchName'.
AAL5 Performance Statistics
Displays performance statistics information associated with an AAL5 virtual channel
connection.
Note - AT-AR240E : The Port Number parameter is not relevant and should be
ignored.
Note - AT-AR250E/AT-AR255E : The AAL5 Performance Statistics sub-menu option
does not display the correct parameters. Instead, it displays the sub-menu option
name as a parameter with a value of 'noSuchName'.
PPP Menu
From the PPP menu, you can view and edit Point-to-Point Protocol information such as Link
Control Protocol information, Link Quality Report information, PPP tests, MAC Bridging
over PPP, IP over PPP, and security protocol.
PPP Link Group
PPP Link Status
Displays management information about a particular PPP Link.
PPP Link Configuration
Displays configuration information about a particular PPP Link.
Note - The current firmware version does not allow the Initial MRU parameter to be
configured. Attempting to configure this parameter will not result in an error but
the new value will not be applied.
Note - The current firmware version does not allow the following parameters to be
configured:
o
Receive ACC Map
o
Transmit ACC Map
o
Magic Number
o
FCS Size
Attempting to configure these parameters will result in the error message: "The
error occurred with 'Set' operation. Error: bad value."