Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 39)

AlliedView™-EMS 3.11 Device Management Guide Page 39 of 402
Host Parameters
Displays the corresponding value of the different host parameters.
Terminal Debug Mode
Displays the terminal debug mode password.
Note - The current firmware version does not allow the Terminal Debug Mode
Password to be configured.
Telnet
Basic Info
Displays the basic telnet information.
Telnet Sessions
Displays the login time, client ip address and telnet session status.
CLI Info
Displays information if the file is enabled or not.
LCLI Info
Displays information about the device's Telnet sessions and SSH sessions if enabled
or not.
Note - Valid MIB Set values for the History Size, Telnet History Size and SSH History
Size parameters are in the range [10-160] inclusive. Attempting to set these
parameters to a value outside of the valid range will result in the error message:
"The error occurred with 'Set' operation. Error: bad value."
RS-232
Displays the configuration of the baud rate of the device.
Web
Displays the configuration about the HTTP and HTTPS Port the device used.
Date and Time
Time Synchronization
Displays the configuration about the device's date/time and time zone.
Note - The current firmware version does not allow the Managed Time and Managed
Date parameters to be configured.
Note - Device Manager always treats objects of type OCTET STRING as a sequence
of bytes in hexadecimal format and does not convert them to plain text format
when necessary. As a result, the DST End and the DST Start parameters will neither
be readable nor configurable.