Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 166)

AlliedView™-EMS 3.11 Device Management Guide Page 166 of 402
Note - If the In CLI (Calling Line Info) Check parameter is set to 'present' or
'required', the In CLI (Calling Line Info) Check List parameter gives the index of the
CLI list to check against. The value of CLI list indices ranges from 1 to 100. The
value 0 means that no list to check against is defined and the check immediately fails.
Note that when using the command line interface, CLI list indices range from 0 to
99, but when using Device Manager, they range from 1 to 100. This is because
SNMP will not allow a table index to have the value 0, and the command line usage
of indices from 0 to 99 is too well established to change.
Note - The PPP Template parameter specifies the PPP template to use when creating
dynamic PPP interfaces for calls generated. The value 33 represents a default PPP
template while the values 1 to 32 represent PPP templates that are currently defined
in the router. Note that when using the command line interface, PPP template
indices range from 0 to 31, but when using Device Manager, they range from 1 to
32. This is because SNMP will not allow a table index to have the value 0.
CLI List
Displays the Calling Line Information list.
Active Calls
Displays information about currently active ISDN calls.
Call Log
Displays the call logs.
Call Detail Attachments
Displays call detail attachment information.
B Channel Attachments
Displays B Channel attachment information.
BRI Interfaces
Displays BRI interface information.
BRI Channels
Displays BRI channels information.
PRI Interfaces
Displays PRI interface information.
PRI Channels
Displays PRI channels information.
Frame Relay
DLC Management Interfaces
Displays DLCMI (Data Link Connection Management Interface) information.