Allied Telesis AlliedView-EMS 3.11 DEVICE MANAGEMENT - Manual (Page 131)

AlliedView™-EMS 3.11 Device Management Guide Page 131 of 402
Note - The current firmware version does not allow the following parameters to be
configured:
o
Tinygram
o
Ring ID
o
Line ID
o
LAN ID
Attempting to configure these parameters will result in the error message: "The
error occurred with 'Set' operation. Error: bad value."
Bridge Media Status
Diplays the types of MAC frames that can be sent or received across each of the
system's interfaces.
Bridge Media Configuration
Displays configuration information used to negotiate the MAC types to be sent or
received.
Note - The current firmware version does not allow the Local Status parameter to
be configured. Attempting to configure this parameter will not result in an error but
the new value will not be applied.
IP over PPP
IP Info
Displays IP compression protocol status information for a particular PPP link.
IP Configuration Info
Displays IP compression protocol configuration information for a particular PPP link.
Note - The current firmware version does not allow the Compression parameter to
be configured. Attempting to configure this parameter will result in the error
message: "The error occurred with 'Set' operation. Error: noSuchName."
Note - The current firmware version does not allow the Administration Status
parameter to be configured. Attempting to configure this parameter will not result
in an error but the new value will not be applied.
PPP Security
Security Configuration Info
Displays the security configuration information for a particular PPP link.
Note - The current firmware version does not allow the Protocol parameter to be
configured. Attempting to configure this parameter will not result in an error but
the new value will not be applied.